Skip to content

Finished parts, process studies and concepts.

Recreated parts, prototypes, enclosures and short runs. Each entry shows its status: done, process study or a concept that is not built yet. Filter by the type of work.

21 / 21
  1. 01Worm gear set for a machine tooldoneReverse Engineering2026
  2. 02Pontiac GP armrestdoneReverse Engineering2026
  3. 03Jeep Wrangler step paddoneReverse Engineering2024
  4. 04Flower guillotinedoneReverse Engineering2025
  5. 05FOX adapterdoneReverse Engineering2025
  6. 064x XLR studio wall boxdoneProduct Design2026
  7. 07Building numberingdoneSeries2025
  8. 08NGH clay stampdoneProduct Design · Brand2026
  9. 09Joker CupdoneSeries · Brand2025
  10. 10Corner TattoodoneProduct Design · Brand2025
  11. 11Żar lampsdoneProduct Design2025
  12. 12Kiteboard handlesdoneProduct Design2025
  13. 13Mietha spinning keychaindoneSeries · Brand2024
  14. 14Gdańsk Crane model from a dronedoneReverse Engineering · 3D Scanning2025
  15. 15Pizza ovendoneProduct Design2022
  16. 16Disposable lensdoneProduct Design2025
  17. 17Atomos monitor hooddone2025
  18. 18Engine to gearbox adapterprocess studyReverse Engineering · 3D Scanning2026
  19. 19Moss wall from a photoprocess studyProduct Design2026
  20. 20Slip-casting machineconceptProduct Design2026
  21. 21KNOBY T1N-POTconceptProduct Design2026
The original: the bronze worm wheel on a measuring mat, 90 teeth, ⌀175 mm.
Render from the STEP models in the documentation (PyVista): the worm wheel and the split worm in mesh, 106.81 mm centre distance.
The original: the worm wheel from above on the measuring mat, 22 holes on several circles.
The wheel grooves up close: hobbed, running out through the bottom face.
The grooves against the light: a flat root about 1.0 mm wide, the trace of the hob tip.
Worm gear set for a machine tool
Reverse EngineeringOpen →